related documents
- 3D FEA Thermal Modeling with Experimentally Measured Loss Gradient of Large Format Ultra-Fast Charging Battery Module Used for EVs Conferences
- A Comparative Analysis for Six-Phase Motor Configurations Conferences
- A Comparative Study between Physics, Electrical and Data Driven Lithium-Ion Battery Voltage Modeling Approaches Conferences
- A Comparison of Componentization Constructs for Supporting Modularity in Simulink Conferences
- A Computationally Lightweight Dynamic Programming Formulation for Hybrid Electric Vehicles Conferences
- A Dynamic Programming Algorithm for HEV Powertrains Using Battery Power as State Variable Conferences
- A Review of Production Multi-Motor Electric Vehicles and Energy Management and Model Predictive Control Techniques Conferences
- Adaptive Real-Time Energy Management of a Multi-Mode Hybrid Electric Powertrain Conferences
- Additive Manufacturing Experimental Infill Testing and Optimization for Automotive Lightweighting Conferences
- An Adaptive Flux-Weakening Strategy Considering High-Speed Operation of Dual Three-Phase PM Machine for Electric Vehicles Conferences
- An Investigation of OME3-Diesel Fuel Blend on a Multi-Cylinder Compression Ignition Engine Conferences
- An Iterative Histogram-Based Optimization of Calibration Tables in a Powertrain Controller Conferences
- Aspects of Migrating from Decentralized to Centralized E/E Architectures Conferences
- Automotive Intermediate Shaft Design & Bearing Selection for Switched Reluctance Motors Conferences
- Chevrolet Bolt Electric Vehicle Model Validated with On-the-Road Data and Applied to Estimating the Benefits of a Multi-Speed Gearbox Conferences
- Combustion Stability Improvement via Multiple Ignition Sites on a Production Engine Conferences
- Combustion and Emission Characteristics of SI and HCCI Combustion Fueled with DME and OME Conferences
- Differential Flatness-Based Control of Switched Reluctance Motors Conferences
- Driver-in-the-Loop Drivability and Energy Efficiency Analysis of Regenerative Braking Strategies for Electric Vehicles Conferences
- Energy Management System for Input-Split Hybrid Electric Vehicle (Si-EVT) with Dynamic Coordinated Control and Mode-Transition Loss Conferences
- Exploring New Joining Techniques of CFRP Cross Member Chassis Conferences
- FRAM Optimization: 3D Print Orientation and Concurrent Topology Optimization for Minimize Mass Problem Statements Conferences
- Frequency-Constrained Multi-Material Topology Optimization: Commercial Solver Integrable Sensitivities Conferences
- High Dynamic Response Full Order Stator Flux Linkage Observer for IPMSM Drives Conferences
- Impact of Plasma Stretch on Spark Energy Release Rate under Flow Conditions Conferences
- Microprocessor Execution Time and Memory Use for Battery State of Charge Estimation Algorithms Conferences
- Multi-Joint Topology Optimization: An Effective Approach for Practical Multi-Material Design Problems Conferences
- Multi-Material Topology Optimization Considering Crashworthiness Conferences
- Multi-Material Topology Optimization and Multi-Material Selection in Design Conferences
- Multi-Material Topology Optimization as a Concept Generation and Design Tool Conferences
- Multi-Material Topology Optimization: A Practical Method for Efficient Material Selection and Design Conferences
- Multi-Material and Multi-Objective Topology Optimization Considering Crashworthiness Conferences
- Overmodulation Strategies for Dual Three-Phase PMSM Drives Conferences
- Performance and Emission Characteristics of Direct Injection DME Combustion under Low NOx Emissions Conferences
- Performance of Spark Current Boost System on a Production Engine under Lean-Burn Conditions Conferences
- Preliminary Testing of n-Butanol HCCI on High Compression Ratio Diesel Engines Conferences
- Review of Production Electric Vehicle Battery Thermal Management Systems and Experimental Testing of a Production Battery Module Conferences
- Rotor Durability Optimization by Means of Finite Element Multiphysics Analysis for High-Speed Surface Permanent Magnet Electric Machines Conferences
- Sequence Training and Data Shuffling to Enhance the Accuracy of Recurrent Neural Network Based Battery Voltage Models Conferences
- Simultaneous Free-Size, Gauge, and Composite Optimization for Automotive Chassis Design Conferences
- Stress-Constrained Multi-Material Topology Optimization Conferences
- Thermal Comfort Simulation for Manufacturing Plants Conferences
- Topology and Build Orientation Optimization for Additive Manufacturing: Influence of Printing on Raft and Build Plate Conferences
- Wear and Corrosion Behaviours of PEA Alumina Coatings on Gray Cast Iron Conferences