Warm forming limits of rare earth-magnesium alloy ZEK100 sheet

Forming limit curves were developed for a rare earth-magnesium alloy, ZEK100-F, at temperatures between 25 and 350 °C in both the rolling (RD) and transverse directions (TD) of the sheet. ZEK100-F contains additions of zirconium (Zr) as a grain refining alloying element and a rare earth addition, neodymium (Nd), that promotes a weakened basal texture allowing enhanced slip activity at lower temperatures. Warm formability measurements were also performed on non-rare earth containing AZ31B-O to examine the relative performance of these two alloys. The ZEK100 material exhibited significantly better room temperature formability over AZ31B-O with a limiting dome height of 29 mm for ZEK100 compared to only 12 mm for the AZ31B-O. At elevated temperatures (250 °C) the difference in formability between the two alloys becomes less pronounced with a LDH of 40 and 36 mm for ZEK100 and AZ31B-O, respectively. What is particularly striking is the pronounced benefit of the rare earth alloyed material at intermediate temperatures, with an LDH of 37 mm at 150 °C which equals the LDH of AZ31B at 250 °C. Similar trends were determined in the measured forming limit curves reported here for the two alloys. The relative performance of the two alloys is largely attributed their initial textures. ZEK100-F also exhibits strongly anisotropic formability (RD versus TD) which can again be attributed to its’ initial texture.