An investigation of the use of heat pipes for machine tool spindle bearing cooling

The results of an experimental investigation into the practicality of using a heat pipe installed in the spindle of a milling machine to remove the heat produced in the spindle bearings which is capable of causing thermal distortion and cutting error are presented in the paper. Measurements of the variation of bearing temperature with time are reported at four different spindle speeds when there was no heat pipe installed, when the heat pipe was cooled by air and when the heat pipe was cooled by an ice/water mixture. Analysis of the results by a simple heat transfer model indicates that the particular heat pipe used was capable of removing up to 160 W with a corresponding 50% reduction in the rise of the bearing temperature above the temperature of the surrounding air at steady operating conditions.