The ATLAS semiconductor tracker end-cap module

The challenges for the tracking detector systems at the LHC are unprecedented in terms of the number of channels, the required read-out speed and the expected radiation levels. The ATLAS Semiconductor Tracker (SCT) end-caps have a total of about 3million electronics channels each reading out every 25ns into its own on-chip 3.3μs buffer. The highest anticipated dose after 10 years operation is 1.4×1014cm-2 in units of 1MeV neutron equivalent (assuming the damage factors scale with the non-ionising energy loss). The forward tracker has 1976 double-sided modules, mostly of area ∼70cm2, each having 2×768 strips read out by six ASICs per side. The requirement to achieve an average perpendicular radiation length of 1.5% X0, while coping with up to 7W dissipation per module (after irradiation), leads to stringent constraints on the thermal design. The additional requirement of 1500e- equivalent noise charge (ENC) rising to only 1800e- ENC after irradiation, provides stringent design constraints on both the high-density Cu/Polyimide flex read-out circuit and the ABCD3TA read-out ASICs. Finally, the accuracy of module assembly must not compromise the 16μm(rφ) resolution perpendicular to the strip directions or 580μm radial resolution coming from the 40mrad front-back stereo angle.A total of 2210 modules were built to the tight tolerances and specifications required for the SCT. This was 234 more than the 1976 required and represents a yield of 93%. The component flow was at times tight, but the module production rate of 40–50 per week was maintained despite this. The distributed production was not found to be a major logistical problem and it allowed additional flexibility to take advantage of where the effort was available, including any spare capacity, for building the end-cap modules. The collaboration that produced the ATLAS SCT end-cap modules kept in close contact at all times so that the effects of shortages or stoppages at different sites could be rapidly resolved.